• Model NO.：S4310
• Surface Treatment：Polishing
• Surface Roughness：Ra0.05
• Standard：GB
• Certification：CE, RoHS, ISO 9001:2000, ISO 9001:2008
• Trademark：dingli
• Origin：China
• Production Capacity：1000

Basic Info.

Model NO. S4310 Surface Treatment Polishing Surface Roughness Ra0.05 Standard GB Certification CE, RoHS, ISO 9001:2000, ISO 9001:2008 Trademark dingli Origin China Production Capacity 1000

Product Description

I. machine use.

This machine is used in casting iron and dry old sand and various kinds of old sand and old sand.

The structural reliability of the machine is easy to maintain and the noise is low.

It is necessary to make a good use of all kinds of cast-iron castings in the production of various types of castings.

The old sand in the machine should be selected and removed.

2. Machine structure.

mass sand by feeding port 1 into the spinning orifice plate roller broken within 13 rises behind sieving, after 14 discharge outlet, sintering lumps by the drum 13 lost to right end of spiral vane, through the grating of 4 wheel blade after collection, from waste 7 mouth eduction.

The xingxing cycloid speed reducer (180cm) is a 180cm (180cm) spring roller.

4. The design of the cylinder crushing sieve characteristics.

I think it's good to know how to do it.

It is not easy to be used for the rolling of the roller.

As a whole, the roller is made up of two pieces of the same axis, which is a kind of smooth and steady flow.

4. The machine is compared with the old drum screen, because the transmission has carrying capacity under large smooth operation, especially to overcome the center big transmission torque, high starting load, impact chain transmission and other shortcomings.

native halftone screen USES the ribbed type fundamentally changed the drum screen, can't work normally because of adhering sand and improve the grinding hard, prolong the service life of the roller.

The time of the short and short time of the machine is to be used for the convenience of the machine.

In order to avoid the phenomenon of the old and the old, the filter is used to break up the old and the old one.

It is not easy to be smooth when it comes to the positive pressure.

It is convenient for you to make use of your customers.

We are in the middle of the system of sand processing, and we have a high quality of sand and dust.

V. machine installation and maintenance.

The section of the shaft with a section of 9 and a half of the roller, with a balance of the top and the bottom of the roller.

The rubber seal of 2 and the hole of the roller 13, the board of the 4 tight contact to guarantee the effect of the dust.

3. Adjust the reducer and coupling door, 10 active roller mutual position, making a coaxial degree not less than 0.3 mm.

The rotating direction of the roller is shown on the right.

In order to improve the quality of the products, we have been able to improve the quality of our products.

Every class of parking garage should be opened to inspect and inspect the inner sand.

but wear or roller roller 12 roll surface uneven wear or producing pits can be removed when the car repair, but pay attention to the two roller roller body diameter and concentric, a pair of roller diameter of each roll.